Protective foil for your workbench

Help for entering measurements

Measure the length and width of your table with a folding rule or a tape measure. Then enter the measurements exactly in the “Length” and “Width” fields.

Surfaces with a rounded edge

For surfaces that have a rounded edge, measure from the point where the rounding stops. That is, from the part of the surface where the surface is straight.

Help for entering measurements

Measure the widest part of your table with a folding rule or a tape measure. Then enter the measurement exactly in the “Diameter” field.

Surfaces with a rounded edge

For surfaces that have a rounded edge, measure from the point where the rounding stops. That is, from the part of the surface where the surface is straight.

Help for entering measurements

Measure the length and width of your table with a folding rule or a tape measure. Then enter the measurements exactly in the “Length” and “Width” fields.

Surfaces with a rounded edge

For surfaces that have a rounded edge, measure from the point where the rounding stops. That is, from the part of the surface where the surface is straight.

Measure the radius

Extend the edge of the table (like the two black lines).

The radius is the measurement from the point where the lines intersect to the point where the rounding of your table begins. You then enter this value in the “Radius” field.

Attention: Please note that you do not subtract the radius from the total length and width. Enter the measurement of the radius in the field provided.

Help for entering measurements

Measure the length and width of your table with a folding rule or a tape measure. Then enter the measurements exactly in the “Length” and “Width” fields.

Surfaces with a rounded edge

For surfaces that have a rounded edge, measure from the point where the rounding stops. That is, from the part of the surface where the surface is straight.

Help for entering measurements

Measure the length and width of your table with a folding rule or a tape measure. Then enter the measurements exactly in the “Length” and “Width” fields.

Surfaces with a rounded edge

For surfaces that have a rounded edge, measure from the point where the rounding stops. That is, from the part of the surface where the surface is straight.

Help for entering measurements

First measure the longest and widest parts of your table. Then enter these values in the “Length” and “Width” fields. Then measure the width and length starting from the corners of the table. (see sketch) Then enter these values in the fields “Length from corner to corner” and “Width from corner to corner”. If your table is straight on one side, then enter the same value in the “Corner to corner” field as for the “Length” or “Width”.

Surfaces with a rounded edge

For surfaces that have a rounded edge, measure from the point where the rounding stops. That is, from the part of the surface where the surface is straight.